Z Motor Mount SPACER - Tevo Tarantula - Z wobble fix
Description
##Tevo Tarantula Spacer For The Spare Z Motor Metal Mount. The 9.5Mm Works For Me, You May Need To Adjust The Height In Your Slicer If Needed. You Need 3 M4X18Mm Screws And You Can Use The Original T-Slot Nuts. (2 Top Frame, 1 Vertical Frame) I Used 2 Washers For Each The Motor Screw, Because It'S To Big, You May Cut It If You Want. ##How To Install - Home Your Printer First - In The Controller Menu Put The Gantry In About 100Mm Height And Holding The Gantry Disconnect The Motor Coupler On The Rod Side. You May Slowly Place The Gantry Down, It Will Be Held By The Rod. - Remove Your Old Mount - Install The Spacer And The Bracket And Be Sure It'S Level With The Top Frame. - Install The Motor Carefully. - In The Rod Nut Tab Loosen The Two Screws A Little Bit. - Connect The Rod To The Motor - With The Gantry At 200Mm Hold The Gantry Up With One Hand And Wiggle The Tab In Place And Tighten It Well. - You May Need To Readjust The Tab. Test It Up And Down Until You Get Minimum Wobble. Subscribe To My Channel For My Channel With Fusion 360 Tutorials: Https://Www.Youtube.Com/Watch?V=4A2Qvezsy5U
Statistics
Likes
5
Downloads
0