Give your 'scope more slope!
Description
This Is An Extended Foot To Increase The Angle Of A Hantek 'Scope For A Better Viewing Angle In A Compact Workspace. It'S An Easy Print, But Make Sure First Layer Adhesion Is Good As There'S Not That Much Surface Area At The Bottom. The Stl Is The Correct Orientation For Printing; Turn Over To Use. There Are 37Mm X 7Mm Indents In The Feet To Place Strips Of Self-Adhesive Rubber Sheet. These Sit Flat On The Bench And Stop The 'Scope From Moving Backwards When You Press The Buttons.
Statistics
Likes
12
Downloads
0