Kossel Pro BIQU Cable support arm. Fits any 2020 frame without screws
Description
My Biqu Pro Has No Cable Support At All For The Cables That Run To The Head. The Cable Tidy Kept Catching On The Side Of The Build Platform And Im Sure It Is The Cause For Some Layer Shifting. This Is My Solution. Prints In Two Parts And Simply Slots Together. You Don'T Even Need A Screw. The Block Has A Turn Key Type Of Fixing That You Slot Into The 2020 Extruded Frame And Turn Until It Is The Correct Way And Tight. Their Are A Could Of Small Holes For A Very Small Cable Tie Or Some String To Fix The Cable To The Arm. My Cable Bundle Is Around 7Mm And Fits Perfectly Into The Clip But If Yours Is To Loose And You Don'T Have Very Small Cable Tie, Simple Use A Bigger One Around The Entire Arm. I Used Colorfabb Ht For Both The Heat Resistance (As It Is Close To The Hot Bed) And Its Durability. Pla Should Work But Make Sure It Is From One Of The More Durable Brands. Ideally Use Either Petg, Abs, Asa Or Colorfabb Ht. Push The Cable Support Arm Into The Slot Before Fixing The Block To The Frame. The Slot For The Arm Is Tight But It Will Go In With Some Force. If You Have Issues Either File The Arm A Bit Or Print The Arm Slightly Smaller. If The Arm Is Too Loose, It Will Come Out Of The Slot While The Print Head Is Moving. ** Longer Arm Added, The Shorter One Just Quite Didn'T Do The Job Over Time. The Clip Has Been Slightly Tweaked To Help Account For An Extra Cable If You Are Running Two Cooling Fans. **
Statistics
Likes
24
Downloads
0