Lightweight Frame V7 for E010 / Tiny Whoop
Description
This Is A Lightweight Frame I Designed For My E010. The Frame Alone Weighs About 3.3G Printed In Abs, And Is Very Durable (Pla Works As Well). I Believe It Will Also Work As A Tiny Whoop Frame Replacement As Well. A Battery Holder Bracket Is Included (Fits The Stock E010 Battery), And Is To Be Super Glued To The Bottom Of The Frame. Flight: Updated Flight Characteristics - Without The Fpv Camera On Board, Flight Performance Is Really Good On This Frame, Using The Stock E010 Flight Controller, Motors, Props, And Battery. Especially Fast In The High-Rates Mode. Flight Time Is Pretty Decent Too. A Higher Capacity Battery Is Definitely Needed For Using The Fpv Camera, Unless You Are Satisfied With 2 Minute Flights. The Flight Characteristics With This Frame Are Quite Different Than The Original E010. It Is Quite Nimble And Tends To Coast, Or Drift, Most Likely Due To The Low Drag Profile. To Explain What I Mean By "Coast", Imagine Flying The Drone In Forward, Then Suddenly Setting The Pitch Control To Neutral. The Drone Pitch Angle Will Level Out, But Continue To Fly Forward For Some Distance While It Slows Down. A Reverse Control Input Is Required To Stop The Drone When Desired. It'S Not Really A Bad Thing, But I Just Wanted To Let You Know About Because It Is A Bit Different Than The Stock Drone Characteristics. Printing: Frame - Simply Print It Flat On The Bed, With The Flat Side Of The Down. No Supports Required. Battery Holder - Will Not Need Supports If Printed Vertically, With The Forward Face Flat On The Bed (The Forward Face Is The End With The Lip, As Shown In The Attached Picture).
Statistics
Likes
21
Downloads
0