Monoprice Select Mini Heated Bed Fix Kit Complete (Chain Update)

Description

Smooth Fit Cable Drag Chain. Safely Reroute Badly Placed Heated Bed Wires Using The Chain Pro Energy Chain For Monoprice Select Mini. -Restricted Radial Motion Version- Https://Www.Thingiverse.Com/Thing:2758569/Zip +Prints A Movable 4 Pack. Print And Give Them A Little Click To Start The Chain Reaction. +Dramatically Improved Stops To Properly Limit Movement. +All Hardware Included Accepting Screws Glues And Kazoos Includes +Fitted Bed Mount, Use Existing Holes As Pilot Holes For Bed Mount. +Clip Together Construction Prints Easily On Monoprice Bed. +Fitted Last And First Links. +Backwards Compatible (Mk-Ii & Mp Cable Chain). +What Dreams Are Made Of. Installation General +Three Holes Need To Be Drilled Into The Back Of The Cabinet Below The Bed. +Open Bottom Of Printer Using Proper Sized Philips (Star) Screwdriver. +Reposition Wires To Prevent Wire Damage During Drilling. +Use Step Drill To Prevent Sudden Drill Penetration. +Fit These Holes After Bed Mount And Chain Configuration. +If You Are Doing This Repair On A New Printer And Are Just Adding Wire You Can Appropriate Heat Shrink Tubing Without The Use Of Solder And Still Have Satisfactory Results. +Glue Type Tube Of 3:1 Ratio Preferred. Wires Sized Appropriately Similar Will Not Get Very Hot In Use. Choice Of Repair Solution Install A New Heated Bed Power Source And Relay Or Solder Equivalent Longer Wires To The Bed Or Use The Existing Wires. This Is A Reasonable Route For The Wires. Existing Wires Connector Clips Should Fit Through The Chain Although If You Chose To Solder In A Few More Inches Of Wire It Allows For Easy Cable Threading. Bed Mount +Remove The Bed To Install The Bed Mount. +Drill The Four Small Holes On Back Of Bed With A Clearance Hole For Your Smallest Nut And Bolts Set Of Four That'S At Least 3/8" In Length. Printing 'Roof' Of 4Xmk_Iii +A Bic Hex Type Ball-Point Pen Can Be Dropped Into The 4Xmk_Iii Print As The Crest Of The Side Walls Begins To Show. The Pen Is A Good Size To Support The First Layer Of The Top Of The Chain. Do Not Use Skirt Or Brim Or Support As These Will Mess Up The Chain. All Layer Height Setting Have Worked Well On This Print. Preferred Setting Info +Prints Best As Positioned In Stl File. +Glass Bed Used In Testing Models. Multiple Links Not Recommended Without A Piece Of Glass. +3.5Mm Or Greater Retract. +30Mm/Sec Print Speed +/- Depending On Quality And Ambient Conditions. +Clear Tough Pla Or Pet-G. Top Range Of Heat For Good Layer Adhesion. +No Brim / No Skirt / No Support +.175 Layer Height Works Very Well. +4 Mm Wall +100% Fill +Bic Pen (Hex Shaped) Inserted Just Before First Layer Of Top Of Chain To Ensure Support Without Getting In The Way Of The Nozzle.

Statistics

Category

Tags