Cable Slitter R1
Description
I Remixed My Cable Slitter. I Added A Depth Adjustment Screw, A Blade Cover, And A Perpendicular Slot. It Works A Lot Better Now. Let Me Know If It Works For You. Or Not... Here'S A Short Video Https://Youtu.Be/3Tnguiz2Kxw I Have Printed This In Pla 220 Nozzle, 60 Bed, 0.2 Layer, 30% Infill Abs 225 Nozzle, 100 Bed, 0.2 Layer, 50% Infill Petg 235 Nozzle, 70 Bed, 0.2 Layer, 25% Infill I Had A Problem With The Hinge On Top Of The Bottom Piece When I Printed It In Abs. So I Added A Patch Hinge. If This Happens To You, Then Sand The Area Smooth And Glue On A New Hinge So All Is Not Wasted. You Can Use Abs Slurry, Super Glue, Or Plumber Abs Cement. Super Strong Stuff. The Single Edge Razor Blade Fits A Little Better In It'S Holder Now. A Little Bit Looser. Mine Will Float Around About 1 Mm Or So. You Still Need To Clean Up This Area Post Print. There Is A Tiny Slot That Gets Fused Back Together (On My Printers Anyway) And It Should Be Cut Apart With A Razor Blade. It Is Located On The Opposite Side Of The Screw, In The Front, 5Mm Up From The Base. It Makes A Locking Tab For The Blade. You Can See It In Thingiview. I Used A 3Mm Bolt For The Hinge And It'S A Little Sloppy. I Think An 8-32 Fits Better.
Statistics
Likes
113
Downloads
0