Wanhao duplicator i3 v2, Z-brace with multiple configuration options.
Description
Z-Braces For Wanhao Duplicator I3 V2. These Braces May Not Be As Rigid As Some Other Designs But It Has Some Advantages. It´S Still Like Day And Night Compared To A Non Braced Frame And I Can Print At Twice The Speed With Even Better Results Than Before. Print All Parts With 100% Infill. Pros: 1. Looks. 2. Can Be Directed To Front Or Rear. 3. Uses Very Little Material To Print. 4. Easy To Adjust, No Tools Needed After Initial Assembly. 5. Will Not Interfere With Your Workspace Around The Build Plate. 6. Make Your Printer Totally Square. 7. Print A Second Set And Mount To Lower Part Of The Tower Or Between The Extrusions For Even More Adjustment Possibilities. 8. Always The Correct Angle. Will Not Initiate Unwanted Bending Forces. 9. No Aluminium? Use A Rigid Board (Min 450X450 Mm) Like Mdf. Place Your Printer On Top And Fasten With Wood Screws. 10. Looks Cons: 1. Not As Rigid As Some Other Designs. (I Think) 2. Some Parts Need Support When Printed. (Bad Design, Sorry) 3. Makes Your Friends Jealous For Having Such A Fancy Printer. Print 2 Pcs Of Each: Top_Plate.Stl (Mirror One Pc) Bottom_Plate.Stl (Mirror One Pc, Need Support) Top_Joint_V2.Stl (Need Support) Bottom_Joint_V3.Stl (Need Support) Locknut.Stl (Need Support) Adjust_Nut_15_Slot.Stl Dt_Nut_18.Stl (You May Need To Redesign Depending On What Type Of Profile You Use) Print 4 Pcs Of Each Angle.Stl Dt_Nut_12.Stl (You May Need To Redesign Depending On What Type Of Profile You Use) Hardware: M4X16 Hex Flat-Head Cap Screw, 2 Pcs M4X20 Hex Flat-Head Cap Screw, 2 Pcs M3X8 Hex Socket Cap Screw, 28 Pcs M6 Threaded Rod 1M (2 Pcs Cut In Length) 6Mm Id Washer, 4 Pcs M4 Nylon Lock Nut, 2 Pcs M4 Nut, 2 Pcs M6 Nut, 8 Pcs Aluminium Extruded Profile, L= 500 Mm, 2 Pcs (I Used A Profile With 8 Mm Gap)
Statistics
Likes
12
Downloads
0