Adjustable Lamp Stand
Description
Adjustable Lamp Stand Where The Height Can Be Changed By Turning A Bolt. This Design Was Based Off Of A Typical Car Jack. It Uses The Same Mechanisms To Achieve An Adjustable Height. Max Height Is Approximately 50 Cm To The Base Of The Light Bulb. All Pieces Are Easy To Print And Optimized For 3D Printing. There Are Clips On One Side Of The Stand To Run The Wire Up. The Top Plate Has Two 5Mm Holes In It So You Can Add Whatever Type Of Light Adapter Or Lamp Shade Holder To It That You Need Either Using Bolts Or Friction Fit. All The Parts Assembly Easily With No Glueing Or Bonding Required, Parts Are Force Fit With Spacers Where Needed. I Am Planning On Printing A Lithophane Lampshade To Put On This Stand And I Will Update The Pictures If That End Up Happening. Feel Free To Send Me A Message Or Leave A Comment If You Have Any Questions Or Feedback. Need: 1-Base Plate 1-Bottomarmside1 1-Bottomarmside2 1-Toparmside1 1-Toparmside2 1-Topplate 6-Bolt2 1-Bolt1 6-Nut 2-Gear1 2-Gear2 4-Spacer Optional: 1-Lightadapter (You May Need To Design Your Own That Is Compatible With The 5Mm Holes)
Statistics
Likes
13
Downloads
0