Mini KshootMania Controller
Description
I Wanted To Get A Real Sound Voltex Controller But Didn'T Have The Money At The Moment. So I Stripped An Old Fight Stick I Made And Modeled A Controller Enclosure For 8 - 30Mm Screwbuttons And 2 - 24Mm Short Stem Screwbuttons. The Pcb I Used To Base The Design From Was An Akishop Ps360+. Instructions: Print The Top Panel First And Install Your Buttons. Print Bottom Panel And Mount Your Pcb (Hole Cutout In The Side Is Sized For An Akishop Ps360+) Print Left And Right Walls Run Wiring From Your Pcb To The Buttons In Your Top Panel Connect Left And Right Walls To The Bottom Panel Slot In The Hinge Pins For The Top Panel Starting First With One Side, And Then Flexing The Opposite Side Wall Slightly To All The Other Pin To Slide Into Place. The Back Wall Is Optional But Helps With Rigidity For Consistent Button Presses, This Would Be The Point Where Print And Connect It If You Wish To Use It. The Cutouts At The Top Are Intended For External Cable Management If You Want To Keep Your Wiring Long Like I Did Instead Of Cutting It To Fit. Build Notes: Attaching Rubber Feet To The Bottom Panel Helps Keep The Controller In Place Much More Easily When Playing. Cutouts At The Top Of The Back Panel Are For Routing Your Pcb Wiring Out Of The Case If You Don'T Cut It To Fit Inside (I Had A Ton Of Excess And Didnt Wanna Recrimp Things).
Statistics
Likes
4
Downloads
0