MakerGear M2 clip on bed level calibration kit
Description
This Is A Bed Leveling Calibration Kit For The Makergear M2. The Indicator Mounts Are Made To Fit The Igaging Digital Indicator You Can Find On Amazon For Around $30 A Piece. Move The Extruder Or Dual To The Center, Drop The Build Plate Down Around 150Mm. After Pinning The Indicator To The Mount Snap It Onto The Top Support. Place The Calibration Block Between The Clips Of The Indicator And Hold Up Against The Bottom Of The Top Support Bar To Zero The Indicator. Remove The Calibration Block Then Move The Bed/Build Plate Back And Forth To Check For Adjustments Needed. Remove Before Printing.
Statistics
Likes
7
Downloads
0