Credit Card / Loyalty Card Holder / Wallet
Description
Are You Fed Up With Those Loyalty Cards Falling Out In Your Pocket Or Handbag And Getting Lost? I Was, So I Designed A Holder For Up To Three Loyalty Cards. The Trick Was To Get Them Thin Enough To Fit But Thick Enough For Strength. They Will Just Fit Into A Credit Card Slot (If You'Re Lucky :-)) I Used Pla, But Abs/Petg Would Probably Be A Better Bet So You Can Get The Strength. There Are Two Sets Of Stl'S - Front & Back And An All-In-One Version. Your Choice. One Of The Pictures Shows The "One Piece" After Printing Vertically Using A 10Mm Brim. This One Happens To Be In Transparent Black Petg. The Two Halves Are Not The Same - One Is Flat, The Other Has 0.6Mm Sides That Form A Box With The Top. After Printing, Remove From The Bed And Glue Using Super Glue (Or Your Favourite). Edit: Superglue Didn'T Cut It For Me, The Parts Kept Separating After A While. I Had More Success With Araldite. Out Of Curiosity, I Tried To Make It In One Piece And It Works - "Loyalty Card Holder One Piece.Stl". Print Vertically With No Supports, Just A 10Mm Brim. You Can Print The Two Halves Together If You Like. Note: Thingiverse Shows Them Vertical, I Printed Them Flat (Make Sure The Tiny Sides Are Uppermost), But I Can'T See Why You Shouldn'T Try Them This Way. If You Do, You'Ll Need A Hefty Raft/Brim To Hold Them Steady.
Statistics
Likes
15
Downloads
0