Z-probe bracket for Duplicator i3 Plus with Diiicooler
Description
This Is An Inductive Z-Probe Mount For An 18Mm Inductive Sensor On The Duplicator I3 Plus With A Diiicooler Installed. This Mounts Between The Extruder Fan And Heatsink, Replacing Those Spacers That Fall Into The Case Every Time You Remove The Fan. The Spacers Are Not A Precision Part, But You'Ll Want To Make Sure The Mounts Are Roughly The Same Size Once Printed And Sand Them Down To About 9.3Mm If They Are Too Large
Statistics
Likes
6
Downloads
0