Anet A8 Z-Motor position meter
Description
Have You Ever Wondered If Your Z-Motors Are Properly Positioned When Going To Home Position? This Is A Very Simple Design But Very Useful To Be Sure That Your Printer Places The Extruder Where It Should Be. Just Have A Look To Your "Meter" And You Will See How Accurate Is Every Time It Goes Home. My Recommended Settings: 0.2Mm/Layer 20Mm/S 100% Infill Print Two Of These And Put Them On Z-Motor Couplers. It Takes About 7 Minutes Each. Please, Post A Picture If You Make This Thing. Thank You!!
Statistics
Likes
58
Downloads
0