CR 10 Feet (uses foam from packaging)

Description

This Creality Cr-10 Foot Design Uses The Foam Packaging Material That Was Included With The Cr-10. The Feet Replace The Existing Rubber Bumpers, And Use The Original Screws. This Made My Printer Way Quieter By Isolating It From The Desk. I Didn'T Expect Much Improvement In Noise, But It Made A Massive Difference. Simply Replace The Rubber Foot With This Part, And Insert The Piece Of Foam (After Cutting The Foam To Length). The Foam I Used From The Packaging Had The Following Dimensions: - Length: 300Mm - Width: 44Mm - Depth: 32Mm The Foam Is Cut Into 4 Pieces, Each About 50Mm In Length. *Note: This Design Uses The Original Foot Plate - Only Remove The Rubber Foot!

Statistics

Category

Tags