Shutter Precision/Exposure Dynamo Hub Connector
Description
Http://Www.Sp-Dynamo.Com/8Xseriesdynamo%20Hub.Html Http://Www.Sp-Dynamo.Com/8-Series-Pic/Connect-Installation.Pdf Instructions For Connector Installation. I Have An Exposure (Rebrand Of Shutter Precision) Pd-8X 6V, 3W Dynamo Hub, For Which I Got Exactly One Contact Housing & Connector. Took The Best Measurements I Could With Calipers; They'Re Very Small Pieces & Therefore Hard To Measure. I Didn'T Take Any Special Measures For 3D Printing; Just Exactly What I Read Off Of The Pieces. Highest Resolution/Layer Height Would Be Recommended. I Am Particularly Concerned About Whether Or Not The Snap Fit Will Work. Untested. Let Me Know If You Do Test It. Update: See The Last Picture. Pictured On The Bottom Is A Shimano Dynamo Hub Connector. The Top Row Are The Respective Sp Connector Components. As Far As I Can Tell, Without Taking Measurements They Should Both Work The Same. The Sp One Is A Bit Wider (So The Interface To An Actual Sp Hub Would Be Nicer), But The Actual Connection Should Be The Same. Shimano May Be Speccing Slightly Smaller Wires.
Statistics
Likes
13
Downloads
0