RC helicopter Jesus nut
Description
I Had This Broken Rotor Piece (The Jesus Nut Of The Rotor) And I Decided To Give It A Try In Recreating One. The Project Was A Success And The Rc Toy Lived To See Better Days. Model And Size: Fq777 For More Info About This Fix, Visit The Project Page On: Https://Hackaday.Io/Project/34326-3D-Fix-A-Helicopter Instructions For Printing: - Print With At Least 2 Layers Of Raft Material - I Recommend 0.2Mm Layer Height - Is Good To Print Two Pieces In The Same Time To Allow The Layers To Cool Down - After Printing, Remove The Raft Material And Use A Drill Bit To Clean The Holes - Use A Carving Knife, Files And Sand Paper To Trim Off And Grind The Excess Material
Statistics
Likes
6
Downloads
0