Universal filament sensor
Description
Update: Hello Guys! I Have My First Kickstarter Project Running! Please Check It Out And Share This Link! Https://Www.Kickstarter.Com/Projects/Kenzoselleslaghs/Rgb-Touchpanel-For-Micro-Controller-S Many Thanks! --------------Edit 11/08/2018---------------- There Is A New Filament Sensor Upcoming Next Week, I Made It Smaller, Less Complicated, And Easy Printable. New One Https://Www.Thingiverse.Com/Thing:3112319 --------------End Of Edit-------------------- This Is A 3D Printed Filament Sensor. It Will Warn You Of Blocked Filament Or Broken Filament. The Arduino Waits For A Certain Time To Pass. If The Sensor Didn'T Put Out Any High Or Low Signal The Arduino Will Respond With A Continuous Beep Until The Filament Moves Again. Ps. I Configurated The Arduinosketch To Work With A Vary Of 3Dprinters, But If May Be Possible That You Need To Change The Values Of The Sensor Depending On What Is Your Printspeed.(Instructions Written In Arduino Sketch) Bom: - Arduino (Uno, Mega, Mini,Etc) (I Have Uploaded The Sketch) - 2X 608 Bearings (8Mm Inner Diameter) - 2X 5Cm M8 Rod. - 9X M8 Nut - 2X M8 Washer - Simple Buzzer - Speed Sensor Arduino - Double Sided Tape (You Need To Put It On The 2 Guide Wheels To Prevent Slipping Rotations) Note.----- Marlin Firmware Users I Am Working On A Solution To Connect This Sensor Directly To Your Motherboard Of The Printer, When The Sensor Gets Triggered He Will Pause The Print And Wait For User Interaction. When I Finish This I Will Post The Extra Code But While You Wait, Feel Free To Use This Instead!
Statistics
Likes
71
Downloads
0