Thermaltake Matrix Front Panel USB
Description
Thermaltake Matrix Computer Cases Come With A Side Usb Panel. This Can Be Rather Annoying If You Have Your Computer Below A Table And Can'T Properly Access The Ports. This Part Provides A Replacement Solution To This. It Changes The Mounting Point Of The Usb Panel To The Front Of The Case, Fitting Inside One Of The Floppy Bays. **Assembly** 1. Print The Part Exactly Like In Stl. You Will Need To Use Some Supports For The Clips. The Orientation Is Harder To Print, But It Will Provide The Best Strength. 2. Remove The Front Computer Case Cover And Find The Usb Panel Module On The Bottom. It Looks Like A Large Milky White Part. 3. Unscrew The Two Screws Holding The Usb Panel Module Against The Cover. Keep The Module Itself Assembled. 4. Pull All Of The Cables Of The Usb Panel Module Out Of The Computer Case'S Depths. 5. Push The Usb Connector Ports, Firewire And Audio Jacks Through The Holes On The Printed Panel. The Screw Holes Should Align. 6. Screw The Usb Panel Module Into The Printed Panel Using The Original Screws. 7. Push The Cabling Through The Floppy Bay And Finally, Push The Printed Panel Into The Floppy Bay Port. It Should Click Into Place, Much Like The Original "Blank" Panels Do. As Usual, I Am Including The Blender Source File In Case You Want To Edit It.
Statistics
Likes
10
Downloads
0