CR10-S E3D Clone Extruder Mount (Large & Small Nozzles)

Description

This Is A No Frills Extruder Mount For An E3D Clone Extruder. The Extruder I Purchased Was Advertised Under E3D, However It Appears To Be A Bit Shorter Than The Actual E3D Extruders. This Is A Remix To Fix This Problem, Unsure If It Would Work With A Normal E3D, But Clould Likely Be Tweaked Easily To Fit. Has Some Additional Features The Last Mount Was Missing, Such As An Extra Bolt On Point For The Top Mount, Making The Extruder More Stable, A Space For The Hotend Cables To Be Wired Back To The Board, And Extensions To Further Stabilize The Extruder. Fits Two Fans, One 30Mm And One 40Mm. (I Swapped Fans From The Original Extruder Mount From The Cr10 And Wired In The New E3D Fan) I Recommend Higher Infill To Help With Airflow. (Airflow Can Be An Issue) You Are Gonna Need A Few Extra M3X20 & A Single M3X8 (Roughly) Screws. Printing: Flip Over The Bigger Part On Its Back So The Flat Part Is On The Bed, Then Do A Few Supports Just Touching The Buildplate To Support The Fan Output. Top Part Can Be Printed Either Way, But Also Requires Some Supports. Large Nozzle Version Has The Fan Output Sitting 3Mm Lower. This Thing Is Remixed From Smellyunory'S Creality Cr-10 Smart V6 Mount. Found Here: Https://Www.Thingiverse.Com/Thing:2560599 And If You Get A Chance Check Out Vektorz.Com

Statistics

Category

Tags