Headphone Holder
Description
I Really Liked The Headphone Holder By Stevetecx Because It'S Small, Simple, And Looks Nice. My Only Problem Was That It Was Structurally Weaker Than It Needed To Be. I Reduced The Overall Length So It'S Now Sized To Hold Heaphones With A Maximum Headband Of 4Cm. I Also Fattened Out The Bottom, Keeping A Taper, To Help Transfer Weight From The Tip Of The Holder To The Base. I Also Changed The Orientation Of The Model So It Prints The Strongest Possible Structure. Stevetecx Says To Use A 3,5X16 Screw. I Just Found A Screw That I Had Left Over From Another Project That Ended Up Being A Bit Bigger. It Caused A Small Split, But The Holder Is Still Strong Enough Now That I Don'T Have To Worry If My Cat Steps On It.
Statistics
Likes
6
Downloads
0