Flat Stanley
Description
Here He Is In All Of His Glory - Good Ol' Flat Stanley! I Started With A Jpg Of Stanley And Converted It To A .Stl At Www.Selva3D.Com. I Imported The .Stl Into Tinkercad And Realized That If I Printed Him As Is His Eyes, Nose, And Mouth Would Just Fall Out. No One Wants A Faceless Stanley :( First Thing I Did Was Duplicate The .Stl File In Tinkercad. We Will Call This "Top Stanley". I Shrunk Original Stanley'S Z-Height Down To 1Mm And Surrounded Him With Shapes (Also 1Mm In Height) So That All His Outside Geometry Was Touching Another Piece Of Geometry. I Built Him Out So That He Was Inside Of A 115Mmx85.25Mm Rectangle Comprised Of Overlapping Shapes. I Grouped All The Shapes. I Turned This Grouping Of Shapes Into A Hole And Aligned It Over Another Rectangle 85.25X115X1Mm. I Grouped Them. The Result Is "Bottom Stanley". I Adjusted T.S.'S Height, Aligned, And Finally Grouped The Two Stanleys. Boom. This Thing Was Made With Tinkercad. Edit It Online Https://Www.Tinkercad.Com/Things/40Aesoguc4F
Statistics
Likes
4
Downloads
0