Customizable Cable Comb
Description
Organize Your Cables And Wires By Using Cable Combs. This Customizable Thing Can Produce Both Open (Clip On) And Closed Combs In All Kinds Of Sizes. You May Change A Lot Of Features To Fit Your Needs. This Thing Uses A Few Levels Of Value Verification To Ensure The Values You Put In Are Feasible. Remember That Printers Can Be Crude And Require More Material To Create A Solid Part. I Recommend Adding A Bit Of Rigidity Through The "Strength" Value And Increase The "Wire Diameter" Beyond Your Measured Diameter Due To The (Often) Small Print Moves Which Most Likely Fall Off A Bit Short. __Changelog__ V1.5 - 2019-02-09 - `Is_Clip_On=1` With Negative `Horizontal_Separation` Now Span Across The Whole Part V1.4 - 2018-12-08 - `Type="Demo"` Introduced To Demonstrate All Other Types - Each Type Is Now Separated Into It'S Own Module - `Size` Is Now Automatically Calculated Based On `Wire_Diameter` And `Extra_Strength` V1.3 - 2018-12-05 - `Type="Slim"` With Extreme `Vertical_Separation` Produced Separated Meshes - Assertion Added For `Is_Clip_On=1` With More Than 2 Rows - `Rows=1` And `Is_Clip_On=1` Now Has A Single Open Side Rather Than Two - Assertion Warnings May Now Be Switched Off Using `Ignore_Asserts=1` - Wires Can Now Be Spaced Apart Using `Horizontal_Separation` And `Vertical_Separation` - `Type="Cut-Away"` Introduced Which Can Be Cut To Size After Printing
Statistics
Likes
186
Downloads
0