Dried PVAc Bed V2.1 for PLA Printing
Description
This Is A Print Bed Suitable For Pla Printing. ##Changes From V2 - Became Printable Without Raft However, If You Print Large Models You Need A Helperdisks. - Does Not Decrease Printable Space ##Requirements - Wet Sandpaper (150 Grit) Or Sander Used To Make The Pvac Layer Thin And Flat. - Pvac Glue - Wet Sandpaper (400 Grit) - Thin Double-Sided Tape For Heavy Use Of Heated Beds, Those With Heat Resistance Are Desirable. - Plane Printbed ##Steps 1. Put Thin Double-Sided Tape On Printbed 2. Peel Off Peeling Layer From Double-Sided Tape 3. Put Wet Sandpaper (400 Grit) On Double-Sided Tape 4. Paint Pvac Glue On Wet Sandpaper (400 Grit) 5. Spread Pvac Glue And Make It Flat 6. Wait For Pvac Glue To Dry 7. Paint Pvac Glue On Dented Part Of Dried Pvac Layer 8. Wait For Pvac Glue To Dry 9. Sanding Pvac Layer Thin And Flat With Wet Sandpaper (150 Grit) Or Sander
Statistics
Likes
3
Downloads
0