Swing Top Cap for beer bottle (1 inch)

Description

This Is A Very Simple, Very Basic Replacement Cap For A Swing-Top (Aka Flip-Top) Beer Bottle/Water Bottle. Printer Settings : - Layer Height 0.15 Mm - Wall Thickness 2.0 Mm - Top/Bottom Thickness 2.0 Mm - Infill Density: 20% - Supports Enabled With These Settings, Printing Time Is Around 45 Minutes Since The Cap Will Be Subject To Pressure, I Did Choose A Slightly Thicker Wall And Higher Density Just To Be Safe. I Didn'T Try Printing It Without Supports, But It Might Work As Well. Requires A Pretty Standard 1" Diameter Rubber Gasket (25Mm) With 10Mm Hole Designed With Onshape. Look For "Swing Top Cap", It'S Public.

Statistics

Category

Tags