Printrbot Stress Relief Ring
Description
I Liked Cbordies' <A Href="Https://Www.Thingiverse.Com/Thing:910309/" Target="_Blank">Stress Relief Arm W/ Tab</A> Model, But When I Printed It I Found That Due To The Open Side It Flexed A Lot. So I Remixed It In Meshmixer To Complete The Ring. Of Course You Do Need A Way To Open The Ring To Allow The Cables To Pass Through. I Printed With Ninjaflex Semiflex 1.75Mm Filament At 240C. I Left A Slight Gap In The Model Between Layers Where The Ring Meets On The Side With The Screw Hole. It Will Likely Merge Together During Printing, But You Can Easily Cut A Flexible Filament With A Sharp Xacto Knife. T Now You Can Separate The Ring To Allow The Wires Through, And Seal It When You Fasten The Screw To The Printer. I Will Use A Small Metal Washer On Top To Help Keep The Fastener From Passing Through The Flexible Part.
Statistics
Likes
0
Downloads
0