Spool holder Anycubic i3 Mega
Description
Designed In Fusion 360...Quite Pleased Indeed :) You Will Need To Flip The Design In Your Slicer So You Can See The Recessed Bolt Holes And The Washer/Spacers Are Level On The Bed :) Uses 22Mm Skateboard/Fidget Spinner Bearings, 8Mm Nuts And Bolts (Found In The Garage). I Did Revise The File For Slightly Larger Holes And Washers As They Were A Bit Tight So These Should Be Spot On. :) Pla 190C Bed 60C...I Did Start Bed At 70 For The First Layer But Think It Was A Bit Warm. Ps Preview Shows The Bottom! Odd But The Other Side Shows The Recessed Holes For The Nuts And Bolts.
Statistics
Likes
251
Downloads
0