Geoffs Solder Holder/Pen
Description
I'Ve Had Short Bits Of Multicore Solder Littering My Workbench For A Long Long Time - So I Liked Kezat,'S Solder Pen, But It Never Printed Correctly For Me. . So - Here'S My Fully 3D Printed Solder Holder/Solder Pen, For 0.8Mm, 1Mm & 1.6Mm Solder Designed To Be Used Flat Or Upright.- And Won'T Fall Off The Bench If Lying Flat. They Hold A Coil Of Solder Inside, Which Is Pulled Out Thru The "S-Bend" Hole, With Some Slight Friction To Stop It Falling Back Inside - Also Includes A Coil Winder Mandrel To Wind The Coil :- 1 - Put In A Variable Speed Drill - Poke 40Mm Out The Small Hole In The End Of The Mandrel 2 - Slowly Wind The Coil 3 - Slightly Loosen The Solder Coil And Remove It From The Mandrel 4 - Straighten The 40Mm End & Insert Thru The Tip 5 - Screw Tip Into Body 6 - Use It (Ok, This Last Bit May Be Unnecessary :-)
Statistics
Likes
13
Downloads
0