Trollhunters Sword of Daylight
Description
My Daughter Wanted The Sword Of Daylight From Trollhunters. I'M New To 3D Printing So I Took It On As A Learning Project. Modeled In Fusion 360 I Made It To Fit On A 5/8 Inch Wood Dowel That Is 25.6 Inches Long. I Made Little Connectors To Strengthen The Seams. When I Put Mine Together, Not All Connectors Ended Up Fitting So I Just Put One In Per Seam. I Think It Had To Do With A Little Distortion In The Base Of Each Print. The Seam Where Both Connecting Sides Were On Top Of The Print They Fit Perfectly. If I Did This Again I'D Print The Blade Pieces On A Raft To Try To Help That Issue. I Printed 6 Connectors But Ended Up Using Only 4. 15% Infill Seems To Have Been Good Enough For Strength. The Only Part That Needs Supports Is The Hilt. I Made The Inner Holes Have 45 Degree Angles. I Glued The Pieces Together Then Blended The Seams With Bondo And Sanded. I Didn'T Have Time To Finish It As Nice As I Would Have Liked. In The End She Wanted It Painted Like The Sword Of Eclipse. This Is A Monster Of A Print. I Think All Pieces Printed In A Total Time Of Around 45 Hours. The Picture Of The Pieces Is How I Oriented The Prints.
Statistics
Likes
311
Downloads
0