Armattan Rooster W2812 LED Holder
Description
This Holder Is Designed To Be Installed At The Rear Of Your Rooster, The Holder Has As Lower Profile As Possible To Keep It Off The Ground, But Sadly Due To Rooster Antenna Placement There Is Only So Much Are Available, As A Result, When Using The Standard Foam Landing Pads This Holder Will Come Into Contact With The Ground, Therefore I Recommend Using A Slightly Thicker Foam Landing Pad On The Quads Arms. When Printing This Led Holder, Try To Keep Your Support Layers At 40%, This Should Give You Some Very Thin Supports In The Led Board Holding Area, As Shown In The Attached Printing Pictures. If You Print Like This, The Led Board Just Snaps Into Place Perfectly (Depending On Led Board Tolerances, You Might Need To Slightly Brush The Pcb Board On Some Light Sanding Paper If It Wont Fit) Enjoy !!
Statistics
Likes
12
Downloads
0