LED mount holder for Maker Select V2
Description
I Really Liked The Led Mount By Rexipus, Https://Www.Thingiverse.Com/Thing:1880015 But It Was A Little Too Big. I Remade The Tray The Led Strip Sits In To Hold Only Half Of It. It Will Still Fit In His Mounting Bracket. I Ordered The Same Led Strips Off Ebay, Https://Www.Ebay.Com/Itm/301032417732 And Then Just Cut The Light Panel Down The Middle Legnth Wise By Scoring It About 10 Times With A Razor And Then Snapping It In Two. The Leds Will Still Work And You End Up With A Panel Half The Size. I Used An M3 35Mm Screw And Nut For The Hinge And Then M3 12Mm Screw And Nut X2 To Bolt It To The Printer. You Need To Have A Rear Mounted Cooler Fan Like The Cii Cooler (Thats What I Use) Https://Www.Thingiverse.Com/Thing:2004629 Just Wire The Led Up To The Extruder Cooling Fan And You Are Good To Go. Now I No Longer Have To Use A Flash Light To See The Print!
Statistics
Likes
25
Downloads
0