Ender 4 PSU Switch
Description
Wandering About Thingiverse I Did Not Find Anything That Could Fit Me For The Space I Have Available And So I Invented This Little Box. I Used All The Recycling Stuff, I Had An Old Power Supply For Broken Pc And I Took The Plug And Switch (From The Power Supply I Also Took The Filter, But Only Because I Found Them In), So If You Buy Them These Are The Specific Names: - Iec 320 C14 (Male Connector) - 6A 250V Switch (Because The 3A One Is Slightly Smaller In Size) I Ran The Cables Behind The Power Supply Plate In The 4020 Slot. To Screw It I Used 2X M4 X 10 With T-Nuts Always Found Here On The Site.
Statistics
Likes
10
Downloads
0