Conterpart for the Avid Artisan Deadalus (right height)

Description

I Remixed The Original To Fit For The Deadalus Coil Maker. The Center Of The Bearing Lines Up With The Center Of The Drill From Deadalus Now. Additional Parts You Will Need: 1 Bearings: Http://Amzn.To/2Ofeido <H2>Print Settings</H2> Infill: 100% Layer: 0,2Mm Nozzle: 230 - 245°C Bed: 70-75°C Support: No Raft: No Used Filament: Yellow: Http://Amzn.To/2Grlk1N I Used The Following Tape On My Cr-10: Http://Amzn.To/2Zxjjgu This Stuff Is Really Great, No Extra Glue Needed, 100% Sticky To The Printed Parts, Which Come Off Really Easily, Even Without Destroying The Tape. <H3>Extra Tip</H3> Another Very Hot Tip Is To Use Kapton Tape! Here You Get The Glossy Finish And Perfect Adhesion Like With The Blue Tape! Look At This: 200Mm Kapton Tape: Http://Amzn.To/2Npggqi Have Fun! (Amazon Affiliate Links)

Statistics

Category

Tags