False Panel Spacers and Retention Screws
Description
I Have Two Computers Installed In One Case. The Case Is The Thermaltake Core W200. As You May Expect, When There Are Two Computers In One Case, Cable Management Suffers Because Hiding Cables From One Side Displays Them On The Other. So...The Only Way I Found To Get A Cleaner Install Was To Purchase Sheets Of Abs Panels In 24"X24"X1/8" And Cut Them To Fit The Case. In Order To Create A False Bottom Where I Could Hide The Cables I Needed Spacers To Create That Void. These Spacers Are 24Mm Tall. They Are Mounted To The Motherboard Tray On Either Side. The Abs Panel (After It'S Been Cut To Fit Properly) Is Then Placed In The Case Up Against The Spacer And The Screw Hole Is Marked And Drilled Into The Abs Plastic. Then Use The Included Screws Hold The Abs Panel In Place. (Not Shown...Currently Drilling Holes So I Can Use The Screws)
Statistics
Likes
7
Downloads
0