Delta Dual Extruder Flying Mount
Description
I Designed This To Suspend My Dual Extruders Above My Hot End. This Mount Should Be Placed Level With The Vertical Slides When The Nozzle Is At 0,0,0. I Put Hook Points On My Slides An There Are Three Hook Attachment Points On The Mount. There Is A Fourth Central Hook Loop For The Counter Balance To Attach To. Printing With Black Pla Makes Photography Difficult At Best. I Hope There Is Enough For You To See Clearly What Is Being Done. If Not Comment And I'Ll Try To Answer Any Questions. I Also Incorporated A Fan Mount To Blow Between The Motors. Without This I Would Suggest Using Abs Due To The Heat Generated By The Hard Working Extruder Motors. Pla Is Just Fine If You Mount And Wire Up The Fan As Always On. Bob
Statistics
Likes
3
Downloads
0