SCX200 - Fenix R1 Pod
Description
Update - R1.2 (Ignore The Numbering On The Print As I Didnt Update It) Two Minor Mods; 1. When Using A 2.1Mm Lens (My Go To) The Corners Of The Image Were Obscured By The Pod. Diagonals Of The Cam Protection Have Been Removed And Now Only The Tiniest Amount Of The Pod Can Be Seen In The Corners. You Really Have To Look To See It Its That Small. 2. The Fin Broke After A Couple Of Gates So It Has Been Made Thicker. I Guess It Was Doing Its Job Of Protecting The Antenna... And It Worked Great With Turtle Mode! -------------- R1.1 Printed In Nylon On An Ultimaker 2+ At 0.2Mm Res. Wall Thickness Is Printed At About 2Mm With 30% Infill. The Camera Can Be Very Difficult To Insert But Warming The Print With A Hair Dryer Will Make It A Little More Flexible And The Cam Can Be Inserted Easier. Https://Rotorbuilds.Com/Build/10771
Statistics
Likes
1
Downloads
0