Tronxy X1 Horizontal Spool Stand on Original Handle
Description
For Those Who Need A Horizontal Spool Holder That Snaps On Easily On Top Of The Original Tronxy X1 Handle Without Having To Remove The Handle. The Is A Remix From Https://Www.Thingiverse.Com/Thing:508896. The Main Thing I Did Was To Design A Cap Piece That Snaps Onto The Original Handle At The Top. I Gave A Bit More Tolerance So That Removal Is Easier, But The Stand Is Quite Stable And Works Well. I Also Adapted The Spool Holder Base From Thing:508896 By Adding A Pair Of Hex-Nut Recesses, And A M3 Compatible Holes. This Enables The Use Of Two Of The Original M3 20Mm Screws Left From The Installation Pack To Secure The Spool Holder Base To The Snap Cap Support That I Designed. Four Positions Are Possible To Allow Situating The Guide-Tube Holder At A Good Position For The Filament Feed. Easy Assembly And Removal. If You Require Other Options For The Centring Nut, Spool Spindle Or Guide-Tube Holder, Please Refer To Thing:508896.
Statistics
Likes
18
Downloads
0