Wanhao I3 Plus / MP BLTouch Bracket
Description
Bltouch Bracket For The Wanhao Duplicator I3 Plus / Monoprice Maker Select Plus. Your Going To Want To Move The Spacers Under The Screws Holding Down The Board, To Underneath The Board. Need To Raise The Height A Little To Clear The Screws That Came With The Bltouch. I Made This Bracket Because The Bracket Provided By Sebastion For Advi3++ Did Not Work With My Setup. You Can Still Use This Bracket And His Wiring / Instructions For The Bl-Touch. Just Make Sure To Correct Your Z-Offset. <H3>For This Bracket, If The Bl-Touch Screws Are Bottomed Out, The Offset Is ~"-2.1"</H3> <B>Although This Offset Works For Me, Yours May Differ Slightly! After Getting Your Firmware Updated And Installed, Use The Command "M851" To See Your Current Z Offset. Ideally Your Nozzle Should Touch The Bed At Z0. You May Need To Print A Test Layer To Determine If Your Nozzle Is Too High/Low If The Nozzle Is Too High, Then Decrease Your Offset Closer To 0. Eg. -1.8 Too Low, Increase In The Negative Direction Farther From 0. Eg. -2.5 This Can Be Done By Typing "M851 Z(Insert Offset Here)" Eg, "M851 Z-2.0" This Would Bring The Nozzle .1 Mm Closer To The Bed. Repeat These Steps To Either Raise Or Lower Your Nozzle Until It Is Perfect. Once Completed Send The Command M500 To Save Your Settings And Never Worry About Leveling Your Build Plate Again!</B> Sebastions Instructions For Wiring The Bl-Touch -- Https://Andrivet.Github.Io/Advi3Pp-User-Manual/03-Bltouch.Html Advi3++ Firmware And Instructions To Get It Working. -- Https://Github.Com/Andrivet/Advi3Pp-Marlin <I>If You Would Like To Follow My Instructions I Have Linked The Instructable Below. I Ended Up Replacing The Zmin Endstop To Home The Printer Using The Bl-Touch, I Did Not Want The Z-Min Endstop To Still Be Present. This Does Require Modification Of The Marlin Firmware Via His Source Code And Changing The Pinouts For The Probe And The Z-Min Endstop And Is <B>Only Recommended For Advanced Users.</B> </I> However, This Is Not How Sebastion Mounts Or Connects The Bl-Touch For His Version Of Firmware. My Instructions (Just Replace The "Button" With The Bl-Touch) -- Https://Www.Instructables.Com/Id/Adding-Automatic-Bed-Leveling-To-Wanhao-I3-Plus-Wi/
Statistics
Likes
59
Downloads
0