Hobbyhorse wall-mount holder
Description
First I Added Eyes To To Horse Head, Because Without It Looked Quite Creepy. I Scaled This To Be 30Mm Wide. The Holder Is For A Hobbyhorse And Should Fit Rods Until 25Mm Diameter. To Mount This To Any Flat Surface I Use 3M Double Sided Sticky Tape: Http://Amzn.To/2Owoq1M Very Strong And You Can Remove It Without Having Left Any Glue, Like A Powerstrip. <H2>Print Settings</H2> Infill: 25% Layer: 0,2Mm Support: No Raft: No Print-Time: Approx. 3,5H Used Filament: Sunlu Baby Pink (Pla+) Http://Amzn.To/2Nv0Qts I Used The Following Tape On My Cr-10: Http://Amzn.To/2Zxjjgu This Stuff Is Really Great, No Extra Glue Needed, 100% Sticky To The Printed Parts, Which Come Off Really Easily, Even Without Destroying The Tape. <H3>Extra Tip</H3> Another Very Hot Tip Is To Use Kapton Tape! Here You Get The Glossy Finish And Perfect Adhesion Like With The Blue Tape! Look At This: 200Mm Kapton Tape: Http://Amzn.To/2Npggqi Have Fun! (Amazon Affiliate Links)
Statistics
Likes
8
Downloads
0