Toolless PiPlate for RPi 2 or 3
Description
I Know It Fits My Pi2, Should Fit A 3 As Well. Print Two Clips And One Plate, Pi Sits In Plate On Built In Standoffs And Clips Push Up From The Bottom And Snap Onto Either Side Of The Board To Hold It Down. Notice - Print The Clips Laying On Their Sides, Not Standing Vertically. You Don'T Want The Layer Lines Running Across The Clip Legs, It'Ll Make Them Weak. Piplate Hdmi Audo Is The Same Plate With Clearance For These Plugs If You Need Them. Piplate Usb Has Clearance For Larger Usb Plugs As Well As Hdmi And Audio Clearance. Update 3/02: Printed Out The Piplate_Usb Model. Fits Fine, Photos Added. I'Ve Since Used This And Derivatives For A Couple Different Pis, Both Pi 2 And Pi 3 Models Fit Fine. Serves My Purpose As A "Module" That I Can Add Parts To And Create Different Mounts. See My Two Security Cameras For Examples, Both Were Made With This As A Basis. I'Ve Had No Problems With The Clips Either, Printed In Pla They Seem To Do The Job Just Fine. Make Sure To Print Them Laying On Their Side Though, So The Layer Lines Run In The Unstressed Axis. They'Re Oriented Correctly For Printing In The Stls.
Statistics
Likes
3
Downloads
0