A diagonal arm end for the Rostock Max to fit a "sturdy stake"
Description
This Took A Few Tries, But These Rod Ends Fit Well In The End Of A Chopped Off "Sturdy Stake" From Lowes/Etc And Fit Well Around An All Metal U-Joint For The Rostock Max. It Was Designed In Openscad And Those Scad Files Are Included, If You Wish To Modify This For Something Else. Backstory: My Rostock Max Had A Diagonal Arm Snap Due To Something Stupid I Did. I Did Not Want To Buy A New Set From Them, So I Bandaged One For Now Using A Sturdy Stake And Went On To Design A More Permanent Replacement. 0.8Oz For My Diagonal Rod Assembly Before Gorrilla Glue. 0.3Oz For The Original (The New Sturdier Version Is Surely Heavier) Seemecnc Diagonal Rod. I Could Probably Trim Some Weight Off By Removing The Plastic From The Outside Of The Sturdy Stake And Spray Painting It Black. The Picture Shown Is An Old Picture From An Earlier Version.
Statistics
Likes
14
Downloads
0