LM8LUU Bearing Block with M3 Nut trap
Description
This Is A Remix Of One That I Printed Which Had M4 Nut Traps, And Was Designed For An M4 Screw. This Messed Me Up Because Well.... Most Screws On A 3D Printer Are M3 Sized - Whoops! So I Remade The Well And The Screw Holes On This. Print 3 Or 4 And Put On The Underside Of Your Carriage With The 45Mm Lm8Luu Linear Bearings. This Is Going On A Wanhao V2.1 But Can Work On Anything. It'S Less Weight Than The Full Enclosure Ones Too (Less Than Half The Weight).
Statistics
Likes
3
Downloads
0