Under Cabinet LED Power Adapter Mount
Description
My Under-Cabinet Lighting Needed A Power-Brick, So This Is A Mount To Hold It Out Of Sight Under The Cabinet. It Prints In 4 Parts: 2 Brackets You Screw Into The Cabinet (Left/Right) And Two U-Shaped Brackets (Front-Back). The Version I Uploaded Also Has A Protrusion On One Side For Holding Extra Wires - You Can Turn That Off In The Customizer. This Is Designed With A Full Length Of 140Mm, A Main-Body Width Of 80Cm, And Supports 50Cm Long. That Means The Power Brick Is Well Supported, But The Front/Back Pieces Won'T Be Touching. This Size Fits A Fairly Large Power Brick, Doesn'T Use Too Much Plastic, And Just Fits On The 12X12 Print Bed Of An Mpsm. All Parts Print Without Support, But You May Need To Re-Orient Them. I Had Some Problems With The Customizer - It Should Work, But If Not You Can Always Download The .Scad File Directly.
Statistics
Likes
2
Downloads
0