Single & Dual paint brush cleaner
Description
I Wanted A Better Brush Cleaner Than A Sour Cream Container So I Decided To Design One. My First Version Was A Single Water Well But Realized That I Didn'T Really Want Two Separate Water Wells One For Dirty Water And One For Clean Water So I Made A Merged One That Has 2 Wells Attached By The Brush Holder Ring. I Was Going To Put A Grid In The Bottom To Let You Clean The Brush Against But It Would Be Way To Hard To Clean The Settled Paint Out Of It So I Went With Rings That Are 2Mm Wide And 3Mm Apart, It Works Very Well And Is Easy To Clean With A Bottle Brush If Needed. I Printed Mine Out Of Petg So I Could Clean It With Hot Water Without It Softening. If You Use This For Anything Other Than Acrylic Paints I Suggest That You Print It In A Chemical Resistant Filament. The Clean Water Well Is Smaller Than The Dirty Water Well As Once Most Of The Paint Is Out Of The Brush The Clean/Rinse Water Doesn'T Get That Dirty That Fast. There Are Two Versions Of The Clean Water Well, I Made One 1Mm Smaller Around As One Of My Printers Was Printing It A Little Bigger Than It Should So That Took Care Of That. (The Ends Of The Half Moon Points Were Coming Out A Little Too Long.)
Statistics
Likes
490
Downloads
0