Modular carriage with magnetic hotend mounts and bltouch support - Tevo Tarantula
Description
This Is A Remix Of The [Modular Carriage](Https://Www.Thingiverse.Com/Thing:1839201) By [_Msa_](Https://Www.Thingiverse.Com/_Msa_) And The [E3D V6 Mount](Https://Www.Thingiverse.Com/Thing:2463575) By [Ahalekelly](Https://Www.Thingiverse.Com/Ahalekelly). Lot Of The Files Contained In This Pack Are Directly Coming From Those Things Without Modifications, I'Ve Just Included Them So It'S Easier For You. Please Check These Original Things Before Using Mine To Make Sure You Understand How To Use And What You Need To Install Those Upgrades. Modular Carriage : - Replaced The Hotend Screw Holes From The Original [Modular Carriage](Https://Www.Thingiverse.Com/Thing:1839201) By [_Msa_](Https://Www.Thingiverse.Com/_Msa_) By 3Mm X 6Mm Magnets Housings - Added An Alternative Xc_P3 Part To Be Able To Glue Leds On An Angle - Included The [Endstop Bracket](Https://Www.Thingiverse.Com/Thing:2463796) By [Ahalekelly](Https://Www.Thingiverse.Com/Ahalekelly) Hotend Mounts : - Modified The [E3D V6 Mount](Https://Www.Thingiverse.Com/Thing:2463575) By [Ahalekelly](Https://Www.Thingiverse.Com/Ahalekelly) To Use Magnets Instead Of Screws - Separated The Fan Parts So Only The Hotend Is Swapped, The Fans Stays Attached To The Carriage - Added A Support For The Bltouch Sensor On The Right Fan - Added A Stock Hotend Mount Following The Same Principle Than The E3D One This Works Perfectly On My Printer, Let Me Know If You Have Any Issue With This Pack.
Statistics
Likes
9
Downloads
0