Heated Bed Stabilizers for Wanhao i3 v2.1
Description
The Standard Ones Made Xyzaxis Didn'T Work On My V2.1, Not Sure If The Bed Carriage Is Different But The Screw Holes Were Too Far From The Sides So It Didn'T Stop Any Wobble, So I Did A Few Changes -Moved Screw Hole To Be Closer To The Corners To So It Used The Sides Of The Bed Carriage To Hold The Bed. -Added A Lip On The Outside Of The Bottom Part So It Holds The Top Piece In Place. -Made The Inner Ring On The Top Part Wider So It Hugs The Spring A Little Better. Attention (Untested) I Have Made 2 Versions Of The Bottom Plate, 1 Has A Lip (0.4Mm) That Will Fit Though The Hole On The Plate, This May Not Work Depending On Your Slicer And Nozzle Size, Should Work Using A 0.3Mm Nozzle (0.36Mm Extrusion Width) Check Your Slicer Preview First, If It Doesn'T Work, Just Print The Non Lipped Bottom Part. I Will Test This Soon Post Printing- You Might Need To Clear The Holes With A 3Mm Drill Bit. I Also Glue The Top And Bottom Parts So They Dont Move At All. I Suggest Printing Bigger Thumbscrews.. My Bolts Are Binding On The Bed Carriageso I Will Look At This Soon.
Statistics
Likes
13
Downloads
0