Babystep Rocker Mount
Description
A Mount For A Simple Switch To Control The Babystep On Your Z Axis. It Can Be Mounted On Any 20X20 Extrusion (One M5X10Mm Screw With Washer And T-Slot Nut Is Required). Wiring Will Depend On The Electronics Board You Are Using. Minitronics Can Use Pins 25 And 26 And Gnd From The Aux1 Header. As For The Switch, Middle Pin Will Be Gnd And The Outer Pins Will Be Connected To 25 And 26.
Statistics
Likes
1
Downloads
0