CR-10 X Axis Level Guide
Description
Update: Added Version For Ppl Who Still Have The Zstop Switch Installed Over Time The X Axis On My Cr-10 Gets Out Of Alignment So I Designed This Guide To Make It Simple To Check And Realign. Screw Them Into Your Extrusion With 2 M4 Screws And T-Nuts. I Leave Them On All The Time, Just Slid Forward In T He Slots So The Hot End Shroud Does Not Hit Them. When I Suspect The Bed Is Unlevel I Raise The Z. Move The Nozzle To The Center. Slightly Loosen The Screws And Slide The Guide Back Till It Touches The Z Frame, Then Snug The Screw. Carefully Lower The Z In Increments Until It Gets Close To The Guides. If It Is Unlevel, Disable Steppers And Turn One Of The Z Axis Rods By Hand Until It Is Level. Then Raise The Z Axis, Losen The Screws And Slide The Guide Back Away From The Frame. Warning I Am Not Responsible If You Do Not Move The Guides Clear Before Operating Machine. The Guides In The Photo Are A Older Version With Extra Screw Holes I Decided Were Not Useful.
Statistics
Likes
53
Downloads
0