50's Ray Gun
Description
This Is An Original Ray Gun Side-Arm I'Ve Drawn Up. It Has Provisions For Leds And Wiring. It Has 23 5Mm Holes Set Up For Lights. Example In Video Below. 6 Go In Each Of The 3 Light Rings 3 Go In The Barrel And 3 Go In The Back "Control Panel" There Is A Slot On The Opposite Side Of The Control Panel For A Button Cell Battery Holder. This Doubles As A Greeblie On The Side Of The Gun And Easy Battery Replacement. Print The Light Ring 3 Times In Transparent Material Print The Barrel In Transparent As Well. Everything Else Can Be Solid. I Used "Natural" Pla For My Lighted Parts. Then Later Paint In The Parts That You Don'T Want To Illuminate. I'Ll Post More Pictures As I Get Mine Painted. The Trigger I Mounted By Using A Chunk Of Pla Strand, Sliding Through The Holes In The Chassis, Through The Hole In The Trigger, And Then Glued The Strand To The Sides Of The Chassis. I Used A Momentary Spring Loaded Button Behind Them To Activate The Lighting And It Springs The Trigger Forward Again. The 1/4" Holes In The Side Of The Forward Body And Chassis Are For Adding A Piece Of 1/4" Tubing For Some More Detail. I Used Some Red Plastic Fuel Line.
Statistics
Likes
36
Downloads
0