INDUCTIVE SENSOR RACK AND PINION V1 - DRAKON EXTRUDER BODY
Description
This Is A Manual Adjust Sensor Carriage For Automatic Bed Leveling. -The Main Problem I Have With Auto Leveling Was That Some Times My Bed (Made Of 3Mm Plywood) Would Possibly Warp. -Another Possibility Is That My X-Axis Would Float Off Of The Lead Screw A Little Bit If I Didn'T Pre-Heat Before I Auto Leveled. -This Always Meant I Had To Redo All The Adjustments Between The X-Axis And The Sensor Height. I Also Never Quite Liked The Adjustments In Available In The Firmware Regarding Sensor Height. -That Is Point Of The Rack And Pinion Carriage For The Sensor. To Decrease Time Spent Adjusting Anything Mechanically And In The Firmware/Software. -Decreasing The Weight And Size Was Also My Goal, Trying To Keep The Sensor As Close To The Nozzle As Possible. Hardware Used* [Not Including All Hardware Used With The Drakon Mount Itself] 1- 4Mm X 16Mm Winged Bolt (I Improvised On This Myself With A Wing Nut And A Bolt, Using Pliers) 1- 4Mm Lock Nut *1- 3Mm Set Screw *1- 3Mm Nut Hope You Like It
Statistics
Likes
7
Downloads
0