Bullet with shell keychain
Description
Nice Little Bullet Keychain. I Didn'T Print It Yet, But I'M Planning To Do So Soon. When I'Ve Printed The Keychain, I Will Post Some Photos Of It Of Course. I Would Print It With .2 Layer Height And About 30% Infill. I Think With Some Supports At The Underside, It Will Be Pretty Easy To Print The Keychain. For The Top, I Recommend Using A Minimum Layer Time In Order To Get A Sharp Tip. Anyways I Would Reeaaly Like It If You Would Share Some Photos, If You'Ve 3D-Printed It! I Wish You Good Luck! :-)
Statistics
Likes
33
Downloads
0